Get Your Rollers Rolling Again And Fix Issues That Cause Doors To Jam

While most people consider a garage door as just another part of the home, it is actually a huge investment. It is recommended that you check and maintain your door often to avoid issues in the long run. There can be damage or cracking on the rollers—this may happen because there is too much friction because of the weight of the door and other problems that can cause it to jam. Here are some of the common issues you might encounter with your garage door:

Worn-Out Rollers

Rollers are the most common cause of door jamming. Worn-out rollers, which can be caused by excessive use or poor quality, will not provide a smooth ride. The door will catch on the roller and stop moving.

The easiest way to tell if your door rollers have worn out is by simply looking at them. If they're cracked or chipped, they need to be replaced. Another good way to tell if a roller needs replacing is if it's bent in any way. If you suspect that your rollers are bad, a repair service can easily replace them.

Broken Springs

Another cause of garage door problems is broken springs. Springs, which are attached to the bottom of the door frame, help support the weight of the door. When a spring breaks or gets weak, it causes the weight of the door to fall on one side of the door frame and not evenly distribute itself across both sides. This puts pressure on one side of the door frame, which causes it to bend or warp over time.

Garage Door Off Track

When your garage door isn't properly aligned, it can cause problems with opening and closing. If your door is off track, the garage door opener will try to move the door out of alignment when it tries to open or close the door. You may be able to fix this problem by adjusting the tracks with a screwdriver or wrench.

Snapped Cables

If you have cables that are snapped, you will need to replace them. You can do this by using a screwdriver or pliers to remove the cable from its housing. Then, attach new cables according to the manufacturer's instructions. To ensure that your cables don't snap again, lubricate them with a light oil and tighten them down with a wrench.

Reach out to a garage door repair technician to learn more. 

Share